24/7 Emergency Plumbing Available — Call 208-919-8496

Whole-Home Repiping

Repiping Services in Nampa & the Treasure Valley

Aging polybutylene pipes, galvanized steel, or repeated leaks are signs your home may need repiping. 1Up Plumbing Services provides whole-home repiping with PEX and other modern materials for homes throughout Nampa and the Treasure Valley.

Call 208-919-8496

Repiping Services

Whole-Home Repiping

Complete replacement of your home's water supply lines with modern PEX or copper piping.

Polybutylene Pipe Replacement

PB pipe (gray plastic) is prone to failure and is no longer manufactured. We replace it with reliable PEX piping.

Galvanized Pipe Replacement

Old galvanized steel pipes corrode from the inside, reducing water pressure and contaminating water. We replace them with modern materials.

Partial Repiping

When only a section of your plumbing is problematic, we can repipe the affected area without replacing the entire system.

Leak Detection

Before repiping, we locate all active and potential leaks to ensure a complete and lasting repair.

Signs Your Home May Need Repiping

  • Frequent or recurring pipe leaks
  • Low water pressure throughout the house
  • Discolored or rusty water
  • Pipes are polybutylene (gray plastic) or old galvanized steel
  • Home is 40+ years old and has never been repiped
  • Water damage from pinhole leaks in walls or ceilings

PEX vs. Copper: Which Is Right for Your Home?

PEX (Cross-Linked Polyethylene)

Pros

Flexible, freeze-resistant, faster to install, lower cost, fewer fittings needed

Considerations

Cannot be used outdoors (UV degrades it); some prefer copper for drinking water

Copper

Pros

Proven 50+ year lifespan, antimicrobial properties, works outdoors, preferred by some buyers

Considerations

Higher material and labor cost; rigid (more fittings); susceptible to hard-water pitting in some cases

For most Treasure Valley homes, PEX is the practical choice — it handles our freeze-thaw cycles well and costs less. We install both and will recommend what makes sense for your home.

Our Repiping Process

1

Free Assessment

We inspect your existing plumbing, identify the pipe material, assess condition, and give you a clear recommendation and written estimate.

2

Permit & Scheduling

We pull the required permit and schedule the work around your availability. Most repipes take 2–4 days.

3

Minimal-Disruption Installation

We make strategic access points to run new pipe with as little wall damage as possible. Water is restored each evening.

4

Inspection & Testing

We pressure-test the new system and schedule the required permit inspection.

5

Patch Guidance

We advise on drywall patching options. We focus on the plumbing — patching and painting is typically handled by a separate contractor or the homeowner.

Repiping in the Treasure Valley

Many Treasure Valley homes built between the 1970s and 1990s have polybutylene (PB) pipe — the gray plastic pipe that was widely used before its failure rate became apparent. PB pipe degrades from the inside out, often showing no external signs until it fails suddenly. Homes from the same era may also have galvanized steel supply lines that have corroded to a fraction of their original diameter, causing low pressure and rust-colored water. If your home was built before 1995 and has never been repiped, it's worth having us take a look.

Repiping FAQs

How long does whole-home repiping take?

Most whole-home repipes take 2–4 days depending on the size of the home and the complexity of the plumbing. We work to minimize disruption and restore water service each day.

What type of pipe do you use for repiping?

We primarily use PEX (cross-linked polyethylene), which is flexible, durable, resistant to freezing, and easier to install than rigid copper. We can also install copper when preferred.

Will repiping require opening walls?

Some wall access is typically required. We work to minimize the number and size of openings and can advise on patching and repair options after the work is complete.

Is polybutylene pipe really a problem?

Yes. Polybutylene (PB) pipe was used widely from the 1970s through the 1990s and has a well-documented history of failure. If your home has gray PB pipe, replacement is strongly recommended.

Does repiping require a permit?

Yes. Whole-home repiping requires a permit in Idaho. We pull the permit and schedule the required inspection. Permitted work protects you when you sell your home.

How much does repiping increase home value?

Repiping eliminates a major red flag for buyers and inspectors. While it's difficult to put an exact dollar figure on it, updated plumbing is a strong selling point and can prevent a deal from falling through during inspection.

Do you repipe homes in Nampa and Caldwell?

Yes. We repipe homes throughout Nampa, Caldwell, Meridian, Boise, Eagle, and the surrounding Treasure Valley. Call 208-919-8496 for a free assessment.

Request a Repiping Estimate

Call 208-919-8496 or fill out the form below. We'll assess your plumbing and provide an honest recommendation.

208-919-8496
Free assessment — no obligation
Licensed Idaho Contractor PLB-C 069959